Reversed Capillary Electrochromatography: Investigation of Peak Symmetry for Eluting Curves of Solutes

Summary A clean method without use of organic solvents has been developed for isolation and high-performance liquid chromatographic (HPLC) determination of oxytetracycline (OTC) and sulphadimidine (SDD) in cow's milk. Isolation is rapid and simple—homogenization with an inorganic acid solution by means of a handy ultrasonic homogenizer, which is easy-to-use and portable, followed by centrifugation. Reversed-phase HPLC was performed on a C₄ column, with 1.25 mmol L⁻¹ succinic acid solution as mobile phase, and identification was by means of a photodiode-array detector. Separation of the analytes was achieved in less than 8 min. Significant linearity was established over the concentration range of 0.1–1.0 μg mL⁻¹ for both target compounds (r>0.99,P<0.01). Average recoveries of OTC and SDD (each spiked at 0.1–1.0 μg mL⁻¹) were ≥88.8, and inter- and intra-assay variability was ≤2.8%. The total time required for analysis of one sample was <20 min. The limits of quantitation of the method (μg mL⁻¹ in milk) were 0.044 for OTC and 0.023 for SDD. No organic solvent was used at any stage of the analysis.     

Particle formation mechanism and kinetic model of ultrasonically initiated emulsion polymerization

A general kinetic model of particle formation in an ultrasonically initiated emulsion polymerization system is presented. This model takes into account homogeneous, micelle entry, and monomer droplet nucleation mechanism. The effects of the ultrasound in producing free radical, degrading free radical and influencing the fashion of the nucleation are also considered. Moreover, chain transfer to monomer and termination in the aqueous phase, capture of oligomer radicals by particles, and coagulation of particles are also considered. An analytical solution is obtained for the initial particle stage consideration. This model predicts that, if the desorption of radical from particles can be neglected, the concentration of the total radical in the aqueous phase is directly proportional to the cavitation concentration. Model predictions are in good agreement with experimental data obtained from the literature.     

Wave chaos in quantum systems with point interaction

We study perturbations of the quantized version ₀ of integrable Hamiltonian systems by point interactions. We relate the eigenvalues of to the zeros of a certain meromorphic function . Assuming the eigenvalues of ₀ are Poisson distributed, we get detailed information on the joint distribution of the zeros of and give bounds on the probability density for the spacings of eigenvalues of . Our results confirm the wave chaos phenomenon, as different from the quantum chaos phenomenon predicted by random matrix theory.SFB 237 Essen-Bochum-Düsseldorf     

The extraction,antioxidant and against β-amyloid induced toxicity of polyphenols from Alsophila spinulosa leaves

Alsophila spinulosa is a tree-like fern, and many evidences suggested that plant polyphenols had the potential therapeutic for Alzheimer s disease (AD). Herein, polyphenols (ASP) was isolated from A. spinulosa leaves and its major constituent were isoorientin and vitexin. ASP displayed excellent antioxidant activity and obvious anti-lipid peroxidation capacity in vitro. ASP improved the survival rate of C. elegans under high temperature by enhancing the antioxidant enzymes activities and decreasing the lipid peroxidation level. Moreover, ASP alleviated β-amyloid (Aβ) induced paralysis and reduced Aβ deposition, decreased reactive oxygen species (ROS) accumulation and improved the level of skn-1 mRNA. In addition, ASP decreased the levels of pdk-1 and akt-1 mRNA in P13K/AKT signaling pathway. In conclusion, ASP may be a potential ingredient for the alleviation of AD.     

Novel polyester/SiO2 nanocomposite membranes: Synthesis,properties and morphological studies

In this paper, a new type of soluble polyester/silica (PE/SiO₂) hybrid was prepared by the ultrasonic irradiation process. The coupling agent γ-glycidyloxypropyltrimethoxysilane (GOTMS) was chosen to enhance the compatibility between the polyester (PE) and silica (SiO₂). Furthermore, the effects of the coupling agent on the morphologies and properties of the PE/SiO₂ hybrids were investigated using UV-vis and FT-IR spectroscopies and FE-SEM. The densities and solubilities of the PE/SiO₂ hybrids were also measured. The results show that the size of the silica particle was markedly reduced by the introduction of the coupling agent, which made the PE/SiO₂ hybrid films become transparent. Furthermore, thermal stability, residual solvent in the membrane film and structural ruination of membranes were analyzed by thermal gravimetric analysis (TGA). The effects of SiO₂ nanoparticles on the glass transition temperature (T_g) of the prepared nanocomposites were studied by differential scanning calorimetry (DSC). Moreover, their mechanical properties were also characterized. It can be observed that the Young's moduli (E) of the hybrid films increase linearly with the silica content. The results obtained from gas permeation experiments with a constant pressure setup showed that adding SiO₂ nanoparticles to the polymeric membrane structure increased the permeability of the membranes.     

Distorted wave response of ultrasonic annular stator incorporating non-uniform geometry

The traveling wave ultrasonic stator is normally fabricated with teeth. The tooth geometry improves the driving speed, but it creates natural frequency splitting and mode contamination, especially a distorted traveling wave. A dynamic model of a stepped-plate periodic stator is developed to examine the distortion. The stator is treated as an annular supported by a thin mid plate, and the support stiffness is formulated by using equivalent energy principle. The effects of the tooth and mid plate on the natural frequency and vibration mode are examined by using the perturbation method. The rules governing the frequency splitting, frequency perturbation as well as mode contamination are also identified. The traveling wave response and elliptical trace on stator surface are obtained by using the mode superposition method and they are proved to be distorted due to the tooth geometry. The response at the repeated doublets becomes coupled forward and backward traveling waves, but that at the split doublets becomes coupled forward traveling, standing and backward traveling waves. The results indicate that the tooth mass instead of the stiffness decreases the vibration amplitude and driving speed of the dominant wave, but their effects are different at the repeated and split doublets. Inspection of the model implies that the distortion can be suppressed by using a suitable combination of the wavenumber, tooth count, tooth height and occupying fraction. Numerical calculations are carried out to demonstrate the tooth geometry effect on the transient waveform, driving speed and elliptical trace. The optimization of the tooth geometry that can help achieve a purer traveling wave is discussed.     

Reprint of : Connection between wave transport through disordered 1D waveguides and energy density inside the sample: A maximum-entropy approach

We study the average energy – or particle – density of waves inside disordered 1D multiply-scattering media. We extend the transfer-matrix technique that was used in the past for the calculation of the intensity beyond the sample to study the intensity in the interior of the sample by considering the transfer matrices of the two segments that form the entire waveguide. The statistical properties of the two disordered segments are found using a maximum-entropy ansatz subject to appropriate constraints. The theoretical expressions are shown to be in excellent agreement with 1D transfer-matrix simulations.     

Wave propagation across a finite heterogeneous interphase modeled as an interface with material properties

Mechanical problems involving an interphase between two well-defined, and eventually different, materials are of interest. The aim of this paper is to present a simplified model that, for low frequency regime, is appropriate for this situation: an interface model with elastic and inertial properties. We present, together with the equations of motion, an identification procedure that is valid for any mass density profile along the thickness of the interphase. For evaluating the accuracy of the model, computations of the reflection coefficients in some relevant cases are shown. Besides, a finite element method is used as a benchmark for both the high and low frequency regimes. It is worth to be noted that the numerical test has been inspired by the problem of the interphase that is formed at the bone-implant boundary.     

Energy flow along the medium-induced parton cascade

We discuss the dynamics of parton cascades that develop in dense QCD matter, and contrast their properties with those of similar cascades of gluon radiation in vacuum. We argue that such cascades belong to two distinct classes that are characterized respectively by an increasing or a constant (or decreasing) branching rate along the cascade. In the former class, of which the BDMPS, medium-induced, cascade constitutes a typical example, it takes a finite time to transport a finite amount of energy to very soft quanta, while this time is essentially infinite in the latter case, to which the DGLAP cascade belongs. The medium induced cascade is accompanied by a constant flow of energy towards arbitrary soft modes, leading eventually to the accumulation of the initial energy of the leading particle at zero energy. It also exhibits scaling properties akin to wave turbulence. These properties do not show up in the cascade that develops in vacuum. There, the energy accumulates in the spectrum at smaller and smaller energy as the cascade develops, but the energy never flows all the way down to zero energy. Our analysis suggests that the way the energy is shared among the offsprings of a splitting gluon has little impact on the qualitative properties of the cascades, provided the kernel that governs the splittings is not too singular.